Our foam meets Federal Spec A-A-59135/59136 (PPP-C-1752D). It is Class 2, Type IV, Grade B, and is 6.0 PCF. The foam resists chemical and caustic jet fuels and is smooth with an easy-to-clean surface.

For toolbox inserts, we usually use ½" thick top foam for the cutout area and heat bond it to a ¼" layer of the same material in a contrasting color. All foam is 6-pounds/cubic foot.

Our foam comes in the following sizes and colors:

 
 
Marine Blue
1/4" x 48" x 108" sheets
1/2" x 48" x 108" sheets
1/4" x 48" x 100' rolls
 
Bright Yellow
1/4" x 48" x 108" sheets
1/2" x 48" x 108" sheets*
*(15 sheet minimum)
1/4" x 48" x 100' rolls
       
 
Deep Black
1/4" x 48" x 108" sheets
1/2" x 48" x 108" sheets
1/4" x 48" x 100' rolls
 
Neon Red
1/4" x 48" x 108" sheets
1/2" x 48" x 108" sheets*
*(15 sheet minimum)
1/4" x 48" x 100' rolls

We can provide any thickness you require, but there is a minimum order of 15 sheets for non-stock/special order foam. ½" foam is not available as a "roll".

Physical Properties Test Method Plank Foam, 6.0 PCF, Type IV, Class 2 Pass/Fail
Compressive Strength-Vertical Direction ASTM D3575 SUFFIX D AT 25% PASS
Compression Set ASTM D3575 TEST A PASS
Compression Creep ASTM D3575 TEST BB - 1000 HR AT 3.0 PSI PASS
Dynamic Cushioning ASTM D3575 SUFFIX CC PASS
Contact Corrosivity FED-STD 101 ASTM 3330 PASS
Flexibility A-A-59135/59136 (PPP-C-1752D) SEC 4.3.3.3.1 PASS
Dimensional Tolerances ASTM D3575 PASS
Water Absorption ASTM D3575 SUFFIX L PASS
Thermal Stability ASTM D3575 SUFFIX S PASS
Static Dissipative EIA 541 APPENDIX F PASS
Surface Resitivity EIA 541 SEC 4.3 PASS

   

Back to Our Products